The causes of deficiency of rubber injection molding machine in the system flow and the solving measures
1, caused by a lack of hydraulic pump flow rate, the system flow is insufficient, should check whether have damage, hydraulic pump parts in a timely manner to replace or repair damaged out-of-tolerance; If because of the suction of the pump air influence the flow of hydraulic pump, should take measures to prevent the air suction, variable pump with variable institutions work effects of pump flow, deal with variable organization removal, cleaning or repair, replacement;
2, pressure distributing valve to poor work flow is insufficient, should repair or replacement;
3, due to the oil viscosity is not appropriate and affect the flow, to replace the appropriate oil viscosity, and pay attention to the influence of oil temperature on the viscosity;
4, overflow valve work bad traffic, should take measures to make it work normally;
5, due to the hydraulic cylinder, valve components such as leakage is serious, cause flow is insufficient, should take corresponding measures according to different situation;
6, flow control valve adjusting mechanism of the work is not normal, should be updated according to the parts damage repair or cleaning, or apart, make flexible adjusting mechanism movement, working properly.