Vulcanizing machine working principle and function: when the vulcanizing machine motor, oil tank classifies oil filter into the oil pump, oil pump and the oil drain into the control valve, at this point, if the hand control valve in the closed position, the oil through the tubing into the cylinder and control valve, drive plunger rise, as mentioned earlier, when the stress reaches e. after, if stop the motor running, check valve automatically shut down, so as to keep the pressure inside the cylinder down if the hand control valve is opened, is a lift platform and weight of plunger, the oil cylinder oil through the oil cylinder of the hand control valve and tubing pressure back to the oil storage box, hot plate, pressure gauge is controlled on the control valve, and connected to the hydraulic cylinder.
Vulcanizing machine, the machine is suitable for all kinds of mold products, such as rubber and plastics, can also be applied to laminate. The machine bed for four-post type integral structure, suppression of pattern for the next (up) pressure type, host, fuel tank and electric cabinet. The host with a plunger, oil cylinder, fixed tablet, tablet etc. Tank of oil pump, pipes, valves and other components. Oil pump motor drive, electric cabinet is equipped with push button switch, magnetic starter, timing alarm, temperature control, overload protector, etc. When the motor overload can automatically cut off power supply, electric heating temperature control, the automatic temperature control in three road, can be adjusted within the range 20-200 degrees, after reaching the temperature, the circuit can automatically to keep constant temperature, reach the set of vulcanization time.